Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello-BOOTLDR: C3750 Boot Loader (C3750-HBOOT-M) Version 12.1(14r)EA1a, RELEASE SOFTWARE (fc1)System image file is "flash:c3750-ipbase-mz.122-25.SEB4/c3750-ipbase-mz.122-25.SEB4.bin"Can't get SNMP working on 3750:snmp-server community public ROWhen t...
Hello-Is there any way to configure 3825 to ensure that all packets have a source IP address that matches the correct source interface (similar to ASA's 'ip verify reverse-path interface')?Currently, we manage anti spoofing with a bunch of ACLs, ho...
Hello-Appreciate your assistance with the selection of antenna for AIR-AP1252AG-E-K9.It will be installed in a big warehouse: 50 meters in length, 20 meters in width and 5 meters in height. I doubt we can mount it on ceiling, but on the wall only. ...
Hello-I'm configuring trunking on Catalyst 2960:interface GigabitEthernet 1/0/1switchport mode trunkHowever, if I do 'show vlan' I can see that GigabitEthernet 1/0/1 still belongs to default VLAN 1. I'm not sure whether it was the case with old swit...
Hello-I have a switch A carrying VLAN AA and switch B carrying VLAN BB. Both switches are connected to switch C which should transfer both VLANs to switch D. The end equipment from VLANs AA and BB is going to be connected to switch D.Would regular ...
It shouldn't do this. Is the trunk link actually up/up ? If not can you make sure it is and then do "sh vlan" again.Thank you Jon!The trunk is indeed down/down, so probably that's the reason why I see this weird behavior. Will revert once I put the ...
