Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I had to configure remotely a new VLAN interface on a cisco switch that had this vlan configuration :(I am connected remotely using telnet on 192.168.130.32)interface Vlan1 ip address 192.168.130.32 255.255.255.0 no ip route-cache!So as I understo...
Hi Gregory,You're right this is the answer. By comparing another switch 2950 configuration on another site that is configured in the same way I have 2 vlan interfaces with 2 different ip adresses but one interface is "shutdown". The first switch i wa...
Hi everyone and thanks all for your answers, the swich is a 2959 24 ports@gregory As I understand the default route should not be used on this switch I think cause it's a command line I suppose for a multi vlan rooting (I don't know if you understand...
Thanks for your answers.@pdriver, this is a good idea to restart the switch cause I saved the changes but before adding the command line "no shutdown" so that should work !10.58.197.32 is a LAN adress you should see this switch as a simple layer 2 sw...
