Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Does anyone have any idea how long it will be until we see OSPFv3 authentication in NX-OS? We now have it in both IOS and IOS XR, but the latest releases of NX-OS still do not support it.
Hi everybody, I recently found myself in need of configuring VRF segregated IPv6 routing with OSPFv3 in a pair of IOS 6500s. After a bit of research, I found that although the latest IOS releases for the 6500 (15.1(1)SY for the Sup720 and Sup2T) ...
The 1921 is a lower end model then the 1841. It has less sustained throughput then the 1841's 38 Mbps.A proper replacement for the 1841 would be a 1941, though at this point you may want to consider going straight to a 4321, or a 4331.
Because the 1921 is intended for very small SOHO deployments. It only has a sustained throughput rating of 15 Mbps. You typically would not be using a rack in a deployment that small, you would just stick it on a desk or a shelf. Some folks do use it...
Is there more to your setup then is indicated in your diagram? You cannot just connect a FEX to a router you need the FEX to be connected back to a nexus mother switch.
A few things here:1. When you put "copy xmodem: flash: file name.bin" you are just using shorthand, and are actually putting in "copy xmodem: flash: [actual name of the IOS image you want to transfer]", correct?2. Ommit the space after the "flash:", ...
