Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, is there a conversion possible for these commands ( on wlc 5508 ) converting to a wlc 9800 local-auth eap-profile cert-issuer cisco Phoneslocal-auth eap-profile add Phoneslocal-auth eap-profile method add fast Phoneslocal-auth eap-profile cert-v...
I have an issue with cisco prime 1.3 , after a reboot I do not see in design, monitoring configuration any templates or features anymore, where are they gone?thx
hey, I have the following issue , our monitoring device (smarts) says often that the treshhold of discard rate is exceeded (.1.3.6.1.2.1.2.2.1.19.1.3.6.1.2.1.2.2.1.13)of the interfaces of 2960 ( WS-C2960S-48LPS-L 15.0(1)SE2 ...
I have an issue with cisco prime infrastructure 1.3 and cisco 880 routers, every 15 minutes the cpu goes to 100% on those routers, but I cannot find the job on the prime which is causing this, if I look in the job dashboard I have some jobs like sam_...
Hey,I have the following problem.I have removed a module from a 6513 ios 12.2(18)Now I want to remove the config from this module (I don 't have the module anymore)anyone knows a ios command???thanksFilip
that patch is already installedCisco Prime Network Control System------------------------------------------Version : 1.3.0.20Patch: Cisco Prime Network Control System Version: Update.4.16Patch: Cisco Prime Network Control System Version: Update.3.10...
thx, but this is the issue , we don not see errors but still the snmp tool like smarts says there is a high discard rate, can it be a bug of some kind?
I am sorry but there is no duplex mismatch and also when a buffer is running out , should this not been seen in the stats of the interface?GigabitEthernet1/0/48 is up, line protocol is up (connected) Hardware is Gigabit Ethernet, address is c40a.c...
