Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
If i create an ASAv with a VXLAN backed EPG on the AVS switch. How would you do a sub interface configuration on the ASAv, is this possible in ACI/ASAv/AVS I wouldnt be using service graphs for this implementation any ideas
Guys, Is there a way a can police traffic on ACI. I need to limit traffic on a particular EPG, i know i can create a custom QoS policy but not sure how i can rate limit it.I figured i could probably mark the traffic and then send into 7k and police ...
I need to route leak between VRFs in the same tenant, i know how to do it for Inter Tenant but i cannot get it working when inside the same tenant with two different VRFs using different BD. any ideas thanks
Hi Guys. I want to create a RSPAN session on the 1000v, i need to copy packets from a veth local interface and send the packets into a different flat L2 vlan, is this possible because i only see that 1000v can do local span and erspan?thanks
Yeah i will raise a TAC for sure. One thing about the above, i would need to do this per tenant, however there will be different levels of bandwidth given to customers, using the global doesnt make sense because you cannot create more levels.You can ...
Yeah i have read that but unless i am been stupid, this doesnt rate limit traffic. If i wanted to rate limit a VM to 100mb for example, i was hoping i could do that on an EPG. If i was using Vmware Distributed switch, i could do this, however i am no...
You would have to use EPG to section out customers and probably share VRFs in ACI. Your contracts would need to be spot on though due to security. I did a design a month a ago around this however it got massively complicated. I personally think this ...
