Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,Right now I'm using 2 cisco switches (redundant). The model for those switches is Catalyst SW-2960G-24TCL.I'm planning to add more servers to the current network but all the ports in the two switches are occupied.Could you please recommend a n...
Hi,Please refer to the attached diagram.Currently, my network connected to the switch and then to firewall and then to the internet.Recently, some PCs of the same network need to access a new private MPLS network. To accomplish our needs, I need a di...
Hi All,Please consider the attached diagram.- There is no direct connection to side 2 from PC-1.- There is an MPLS link between side1 & side 2, and both local networks can access each other.My question:Can I acess 10.0.1.0/24 network (side 2) through...
Hi All,my current network layout is attached.The service provider will be preparing an MPLS-VPN network as per our request.The required scenario is:Only one PC from the 10.50.10.0/24 subnet is required to connect to mpls network directly. Other PCs s...
Hi,I forgot the community string (password) that configured for snmp. When I ran the show run command, only asterisks were displayed instead.Is there any way that I can display or retrieve it ?Please help !!
Yea that makes sense to me.On FW1; we have default route to the internet, but I'll configure static route for side2 network twards mpls link. Am I right?On FW2: either it will be the same case as FW1 or all the trafic will be routed twards mpls link....
Thanks Jennifer for your helpful response as usual.So, the config will be:access-list NEW-Split-List standard permit 10.0.1.0 255.255.255.0 ip local pool NEW_POOL 192.168.18.1-192.168.18.15 mask 255.255.255.240 group-policy NEW internalgroup-policy N...
Hello Harish,Thank you so much for your help.do you think it's possible to define static ip address for that specific PC?If that possible, the traffic from that pc can easily be routed to go to mpls network. please correct me if I'm wrong.Regards,
