Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi , I hope you can help? I have two 6509's connected together. Using STP and HSRP, I currently have around 80 vlans on the network with odd vlans going to core1 and even Vlans going to Core2. Performance of the 6509's has always been pretty good unt...
Hi, Hope someone can help!!We have recently purchased a second internet link that is to be connected into the ASA for the purpose of servicing VPN traffic to our site. Our primary internet connection due to politics we can't pass VPN traffic.With two...
Hi,Previously with PIX version 6.3 you could debug packets in realtime. i.e with the debug packet command.Looking through the ASA 7.2(2) commands the debug packet command no longer exists. Though the packet-tracer command exists this is not in realti...
Hi,I have a server connecting via 1Gbp ethernet to a 6509. looking on the counters of this port I have no errors other than the Txpause value is high. and users who access this server say access is slow. please see output below.The server NIC configu...
Hi,I have two 6509's at the core of my network (MSFC's and Supervisor module's)After an unexpected power cut the second core failed to boot up, I gave the unit another power cycle and the unit booted up. The router module booted ok.However, when conn...
Hi Arjun
From the captures the TTL=19
The PIM processes were low but the IP input process was high 30% plus
from the logs i'm seeing a lot of the following messages which do stop when i disable the new vlans i created
Oct 29 03:28:19.013: %SCHED-3-...
Hi Jon,Please see the outputs from the 'sh ip pim rp mapping' command:Core 1:Core_1#sh ip pim rp mappingPIM Group-to-RP MappingsThis system is an RP (Auto-RP)This system is an RP-mapping agentGroup(s) 224.0.0.0/4 RP 1.1.1.2 (?), v2v1 Info source:...
Hi Jon,The cat 6509's are the only L3 devices on the network. Whilst I was capturing traffic from Core 2. CPU utilisation was very high. the average I would say was 45% but on burst (every minute) it would be over 80%.I disabled all the new vlans I c...
Hi Jon, Thanks for taking the time to reply to my query. So core 1 does not have a route in it's table for core 2's loopback interface?No, Core 1 doesn't have a route to the loopback interface of Core2 When you did the packet capture was that on both...
thanks for replying Chad.Changing my no_nat statement worked. In the sense that I could now pass traffic now through the tunnel.But setting up the tunnel is still a problem. If I don't add a static route to the VPN client into the ASA, the ASA doesn'...
