Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I have a customer who has ISR 4331 and 4321 on branch sites. There is no UCS-E modules but we do have 200GB SSD storage and 8/16GB of RAM. In this configuration, is it possible and supported to run a low scale vWLC as a service container ?Thank...
Hello everyone,I recently deployed SFR module on ASA 5512-X and I am facing the following issue : One website that is used on a daily basis is blocked since we deployed FirePower services. Actually, it's been categorized as "Malware Site" with a bad ...
Hello,I'm working on implementing a RADIUS authentication for wireless access with the following :- PCs running Windows 7, protocol used is PEAP (without validating the server certificate to make it simple at first),- AP 1252 configured to use a RAD...
Hi,I just upgraded my ACS v4.0 to the latest available version v4.2(1) build 15 patch 2 and I've got some trouble with the CSLog service. I performed a successive upgrade first to v4.2 then to v4.2.1 and finally applied the two patches. Everything is...
Hello,I have a problem with an IPSec tunnel between a 877W router and a 1812 router. Configuration on both routers seems to be OK as soon as the tunnel is going up but goes down after a while. I get those logs :040687: *Apr 16 10:50:44.415 PCTime: I...
Hi Adam,I've just seen that APIC-EM 1.4 is out. Release note doesn't mention our use case, do you confirm that it is included ? I am @ Cisco Live so I don't have time to test right now. If you have time to meet at the DevNet Zone, tell me !Vincent
Thanks for the update Adam.I tried to change the configuration and only set the expected member count (2 in my case) in the stack switch configuration. But I have to at least accept the EULA otherwise I can't save my device. Seems to be the issue her...
Great ! Thanks Adam, let us know when you have an update. For the moment, I will try deploying the first switch in the stack as standalone, pre-provision the others and power them on when PnP is finished. Should work.
When I enable debug pnp all on the stack, I have these logs over and over :Jan 10 16:29:45.059: PNPA-inventory:Stacked switch udi[1]:PID:WS-C2960X-24PS-L,VID:V04,SN:FOC2030V0H4Jan 10 16:29:50.264: PNPA-infra: PKI Initialized[0]Jan 10 16:29:50.264: PN...
