Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello everyone,I'm trying to configure a VWIC2-1MFT-E1, and under the controller config when I try to enter pri-group timeslots 1-31, it says please configure network-clock-participate wic 0 first.So when I go to global config and enter net? , I only...
Hi everyone,I've setup remote access PPTP VPN on a 2801 router (running 12.4 advsecurity).What I'm trying to do is restrict the VPN user to only one IP in the network. I'm having trouble finding out how to get that configured.Here's my config:aaa new...
Hello everyone,I have a 2801 router running 12.4(1c) and have installed an AIM VPN/SSL2 card in it. When I boot up, during POST I get the 'Unknown card in slot 0' error.Is there something I'm missing here? There IS something that I did notice on the ...
Hi everyone,I have a UC500 in the office and some users need to access their voice mail from outside the office.Is there an application that needs to be embedded into the autoattendant script for this?I'm not sure how it's done...Thanks in advance fo...
Hi everyone,I just modified the config in CUE on my UC500 and I was wondering what the impact would be if I reloaded it during business hours.I'm sure the phone calls will not be dropped. I'm thinking anyone leaving voicemail would not be able to do ...
Hi Somnath (the Author),Just to clarify, the two pictures we are having trouble seeing are in section 2.1, right after it says:"In the Configuration Guide for C3750 figure 36-13 (shown below) shows a picture of the buffer pool. The reserved buffer po...
I'm having the same issue as the previous commenters. I've used different browsers as well. Could the author please reupload the pictures to allow us to better understand the article?
Well I guess I have the issue resolved, although I had to take a different route.I used channel-group to bring my E1 up, but I still don't know why I don't have the network-clock-participate command available.Thanks for the responses.Ali
Thanks for the response Jay.Here's the output for show diag:Slot 0: C1841 2FE 2SLOT Mainboard Port adapter, 3 ports Port adapter is analyzed Port adapter insertion time 13:39:41 ago EEPROM contents at hardware discovery: ...
Thanks for the reply, Jorge.I've already tried what you suggested. I've even tried blindly entering the command even though it's not available, but no good.I'm sure it's not platform specific, because I've seen configs on 1800's that have this on the...
