Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Team,I believe I have the answer, but I just want to double check with any of you. I have the following scenario- 3 Locations, each of them with one WLC 4400 running 6.0.188- I have configured all AP's in H-REAP local switching mode, so that I ca...
Hi Team,I have seen these SMB routers and from data sheet at cisco.com website it seems that they support DMPN with OSPF. Is this achieved with NHRP just like you would configure it on a ISR router?. Also, could you confirm if these routers support...
Hi Team,I have an integration between a Cisco Router 2900 and a Nortel PBX CS1000M. They are both connected with an E1 R2 CAS. When we configure the E1 with no ANI request, we are able to dial from cisco to nortel and viceversa. If I enable ANI on...
Hi Sam,I'm having the same issue, but on Windows 7 32-bits machines. Were you able to overcome this problem?... I haven't been able to identify a pattern on machines that prompt "Windows Update Agent is not the correct version", but it happens rando...
HI Guys,Were any of you able to work out WLC 5508 with Windows 2008 NPS. I'm currently running OS 7.x on my WLC and my server is Windows 2008 R2. Any thoughts are really appreciated.Thanks,Sergio
Hi Guys,Thank you very much for your help. Case is solved. Nortel side changed the DTI card for a PRI enabled one and I configured Cisco side like this:isdn switch-type primary-qsigisdn voice-call-failure 0voice service pots supplementary-service q...
