Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
hey guys thanks for looking at my post, i have been setting up internal networks nothing hooked up to the net, but now i want to hook up to the net and need some guidence. my set-up so far is just fairly simple to test for connectivity.i took out ...
hey guys thanks for looking at my post, i have been setting up internal networks nothing hooked up to the net, but now i want to hook up to the net and need some guidence. my set-up so far is just fairly simple to test for connectivity.i took out my ...
my first router had issues saying the the requirment exceed the available memmory and kept cycling through rommon. so i did a tftpdnld to delete all memmory and reload the flash. nothing happend so i thought it might be the memmory module. i took the...
my router has taken a poop. it is in a constant loop when i start it up and loads the image, then i comapared it with another router to see where it malfunctions and this is where is does, it says;00:00:10 UTC Fri Mar 1 2002: Unexp...
ok, so i have my router and made subinterfaces int e0/0no ip addressno shutdownint e0/0.1encapsulation dot1q 1ip address 10.10.10.17 255.255.255.240 and i set my switch up with thisconfig tint vlan 1ip address 10.10.1...
hello i could be wrong but it looks like your vpn's over lapyour 192.168.10.65 is on the 64 suband your 192.168.10.70 is on the same sub of 64, maybe change that to 192.168.128.129 so it is on the 128 subthen make sure you set up vtp for vlan communi...
thanks for the reply, i disconnected the fios and took the main rj45 cable and plugged it into the wan port of the router, could you explain why it would not work im not sure why.i set up the wan interface with 192.168.1.1 255.255.255.0i set nat w...
sorry everyone and thanks i found the problem. the first router having the problem was the module must have popped out the first time(no clue how). then when i swapped i actually did the same thing and did not push hard enough to pop it in all the...
sorry everyone and thanks i found the problem. the first router having the problem was the module must have popped out the first time(no clue how). then when i swapped i actually did the same thing and did not push hard enough to pop it in all the wa...
leo,you were helping me with this issue and i tried somthing and it back fired on me, please help.i figured it was the memmory module that went bad so i took one from another router i had and switched it and it still did not boot, it went to rommon m...
