hey guys thanks for looking at my post, i have been setting up internal networks nothing hooked up to the net, but now i want to hook up to the net and need some guidence. my set-up so far is just fairly simple to test for connectivity.
i took out my fios router and took the main cable and plugged it into my 2010xm router's 1t dsu/csu...
i looked up in windows ipconfig to find the ip address that was being used......192.168.1.3
i then set that address on the serial interface
i then sutup vlan 1 and vlan 2 on the fastethernet 0/0, i am using the vlan 2 and setup the private address as 192.168.10.17 255.255.255.248
i did a:
router eigrp 10
network 192.168.1.0 0.0.0.255
network 192.168.10.0 0.0.0.255
no auto-sum
i then connected the router to a switch and made the int vlan 2's ip address 192.168.10.18 and did a no sh
set the ports for trunking and access vlan 2
i set my computer's network as ip address 192.168.10.19, mask 255.255.255.248, default 192.168.10.17
all of this for internetworing was operational i could ping everything.................................................
no i set-up pat on the router:
ip nat pool connection 192.168.1.3 192.168.1.3 netmask 255.255.255.0
access-list 1 permit 192.168.10.0 0.0.0.255
ip nat inside source list 1 pool connection overload
int s0/0
ip nat outside
int fa 0/0.2
ip nat inside
that is all i have set-up, question is-----
1. is the main internet cable suppose to be plugged into that port or do i need some other device?
2. i know the internal network works but am i missing anything like a dhcp server or somethinng?
3rd thanks
