Hi Folks,I have an installation of CPAR. I need to provision it with REST, however, I am struggling with the documentation. I can send a curl as follows:C:\Users\MyPC>curl "http://<ip>:8080/RESTAPI/service/getobject?typeid=16" -H 'Cluster:'Cluster is...
Hi,
As the title states, how do I enable h323-remote-address AVP to be sent from a Cisco ISR 15.1-4M8, to a RADIUS server.
So far, I only see this AVP in the accounting stop, which is rather pointless
BRALan
Hi Folks,I have a SUP32 running on latest SXI14 but it wont allow me to add the following commandip nat inside source static tcp <non local ip> 22 <loopback ip on the box> 22 extendableI get this error%Port 22 is being used by system min22I need this...
Hi,I have a hub and spoke setup with IPSEC.If interesting traffic comes from the spoke, the IPSEC SA starts and works perfectly. However, once the link idles out and there is no more traffic, the hub shows this with the sh crypto isa sa command196.47...
Hi Folks,I have setup a webvpn system, which works perfectly on a 2811. However, when I enable aaa accounting on the context, it seems to be enabled BUT the accounting packet is never sent.Debug shows thisAug 28 09:55:56 c2811-test 312: Aug 28 07:55:...
Hi Arne,Yes, used that document but it doesn't help at all. Tried everything :( As an aside, how do I configure static IP resource manager? I'd like to give out the same static IP to the same user. I can IP Per NAS port, but i would rather have the s...
Here you go SachinEdge routers are 1801'sHub is a 2811Edge ACL's are a mirror of what is in the ACL's associated to each map lineAs far as I can see the default route is correct and that all the crypo traffic should not be NAT'd or go elsewhere but ...
Thanks Sachin,I suspected this was the case with dynamic maps. but your help has guided me to a better approach.I have now gone for a bunch of static map entries for ky known endpoints and a dynamic at the bottom for the non known endpoints Now, I ju...
I have the same issue, sccp enabled and active for transcoding. Setup an ephone with g726 and a dial-peer with g711ulaw, the call seems to run g711 and doesn't do any transcoding Any ideas?
