Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have ASAs with three security contexts. We have one ISE appliance for TACACS+. Our MGMT context and ISE are routed on MGMT network. Our other two contexts are on different networks. How do we point our other two contexts to our ISE appliance via ...
Hello,I am trying to see if the following can work. access-list extended Out permit udp host 239.10.10.1 range 1020 1030 anyaccess-list extended In permit udp any host 239.10.10.1 range 1020 1030int vlan 10 ip access-group Out out ...
Hello,I have an Enhanced FlexWan module in an 6506e chassis with SUP 720. The modules in slot 3 & 4 have no power. Thru show mod i see pwr down and diag unknown. I issue power enable mod 3 & 4 still no change. I put them in another...
Hi,I am trying to limit the bw of a gre tunnel to 60Mbps and any packets exceed this rate drop them. Problem it seems is you cannot apply a Service-policy output <word> to logical interfaces. So below seems to be the only option:vlan configuraiton 93...
