Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have setup a VPN site to site between 2 firewall. On my site Y, public IP 210.666.111.7 with 1 local LAN (10.145.49.0/24) <--config is belowOn my site Z, public IP 216.55.11.82 with 2 local LAN (10.83.132.0/24 and 10.83.138.0/24) I am trying to rou...
I need slight help understanding redundancy for Cisco 3750-X Switches using the stack cables. I want to ensure when in stack mode, the master and slave switch interfaces are UP so if at anytime the link to the CORE is down, the stacked member of the...
Hi,
I have redundant networks paths for HR-SWI-01, shown in the image attached, the black color (path 1) and green color (path 2) lines.
When both of the paths are enabled MULTICAST traffic travels from HR-SWI-01 through LA-SWI-02 to F-SWI-01 and c...
Hi,
I am configuring a 5506-x for the first time. Without the firewall installed, staff currently access a remote desktop machine internally using the public IP address. I have it configured so workstations internally can access the server in DMZ 1...
I have two interfaces on multiple servers connecting to two switches for iSCSI traffic only. I'm not able to ping any interface IP connected to either of the two switches if I do a ping from either switch. I'm having retransmit e...
Yeah, I have the config for The other side. It looks like this. Thanks : Saved
:
: Hardware: FPR-2110, 6843 MB RAM, CPU MIPS 1200 MHz, 1 CPU (6 cores)
:
NGFW Version 6.2.3.13
!
hostname firepower
!
interface Ethernet1/1
description internet fac...
Yeah, I have the config for The other side. It looks like this. Thanks : Saved
:
: Hardware: FPR-2110, 6843 MB RAM, CPU MIPS 1200 MHz, 1 CPU (6 cores)
:
NGFW Version 6.2.3.13
!
hostname firepower
!
interface Ethernet1/1
description internet fac...
Hi Reza,
Thank you for the help. I was going through marking appropriate posts with an "answer" and stumped on this topic I created.
Quickly Continuing from your previous post:
"Also, regarding the WAN links, what I meant was you have 2 WAN li...
What if the switches are not stacked and there is a VSS between the two switches? In a scenario where the Layer 2 ring is broken, would SWI1 and SWI2 both pass traffic to Gi0/2 Switch2 and Gi/0/1 for Switch1?
Thanks
all traffic will be rerouted to sw2.
You said traffic will be rerouted. However, I would like traffic to still go through sw1 and sw2 because the redundant core fiber needs to keep the tail (g3) up, the label called Path2.
You also want to make...
