Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi guys,
I cannot have access without Identity NAT configured.
Object: LAN
object network LAN subnet 10.100.52.0 255.255.255.0
NAT:
object network LAN nat (inside,outside) static 10.100.52.0 no-proxy-arp route-lookup
I want to emphasise tha...
Hi guys,
I cannot have access without Identity NAT configured.
Object: LAN
object network LAN subnet 10.100.52.0 255.255.255.0
NAT:
object network LAN nat (inside,outside) static 10.100.52.0 no-proxy-arp route-lookup
I want to emphasise tha...
Hi Guys,
I have /16 network subneted to /24 for each store, I need to allow access from the network host .253 from each /24 subnet to a specific services on the DMZ (resides on Palo Alto) and I need one ACE entry in the access-list permit the ....
H All,
We do have split MAC wireless design and we purchased APs that can only support Poe+ for full functionality so we had to purchase 12 switches 2960X which support both Poe or/and Poe+.
One of busiest distribution Centre needed an early inject...
Hi Guys,
I hope you are all well,
I am new to Cisco Prime, we just migrated from Solarwinds and I am finding it difficult to achieve the best way of polling a specific network devices and their specified services or/and interfaces (WAN interfaces. ...
Hi,
I apprecitae the quick reply.
Hi,
Thanks for the update.
Here is the output:
Phase: 1 Type: ACCESS-LIST Subtype: Result: ALLOW Config: Implicit Rule Additional Information: MAC Access list Phase: 2 Type: ROUTE-LOOKUP Subtype: inpu...
