Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
5508 WLC running 8.4.100.0 - firmware upgraded to 8.5.171.0
2800 series AP's upgrade and join with 8.5.171.0 all 2700's fail
All AIR-CAP2702I-Z-K9 on the controller fail to upgrade and will only work again when WLC was changed back to 8.4.10...
currently running port security in AP's operating in local mode..the requirement is to move AP into Flex mode and change to Trunk on SW port to allow local vlan swithing for Corp .1x SSID; remaining SSID's will stay centrally switched. If AP is chan...
I have a working EWC on a 9120 AP , my question is - does the AAA/radius auth data flows only go via the EWC IP addr or does every AP in the network need to be a radius client.Unfortunately I have no access to the clients AAA host so I can quickly t...
Currently have ISE guest portal working for "sponsored guest id's" in ISE , and have added AD lookup in the Guest Portal Sequence.User case is to allow only one specified AD group access to the guest portal/internet , but currently it appears that an...
I have a 9800CL HA/SSO deplyment in operation - version 16.12.3Need to upgrade to 16.12.4 as x.3 has been deferred. Has anyone done a simple GUI upgrade on the Primary (active) unit ? a normal upgrade process automatically migrates the secondary an...
Thank you M for the reply.
I do concur that bug looks to be the issue - but as per current Cisco 8.5.171 release notes - 8.4.100 to 8.5.171 is now fully supported.
However , that does not mean the bug has not re-surfaced in this case!!!
Also - 8.5...
Thankyou ,One SSID is to be locally switched - which is the reason to go flex.We are going to do some testing , but it does seem to be common consensus - remove port security on the AP ports and run as standard config trunk with native.Also , there i...
Thanks for the reply , I think some may misunderstand the initial question.Remote site AP's (local mode to WLC) are already operating with port security in place.Client now wishes to move the AP mode from local to flex - allowing for corp data to be ...
Hi Ammahend,as per last line in reply " No port security on AP port, switch will see connected client mac on AP port."are you saying the AP switchport should not be confiugered for port security ? ie: just a normal trunk port with native vlan. Cheer...
