Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
To revive this topic, the Hyper-V deployment of the WLC 9800-CL requires configuring vNIC as trunk and enabling MAC address spoofing on Hyper-V. Without MAC address spoofing, the WLC has a hard time adding a MAC address on the L2 header, resulting in...
There are no restrictions that I am aware of for configuring Flexconnect for an AP. If you try to configure something that is not allowed on the WLC, you will see an error message explaining why you can't do it. Is that your case?
You can't connect the AP from Canada to your WLC in the US because each country has a different RF domain. However, you can add Canada as a supported country to your WLC configuration, then the WLC will accept the connection with your AP in Canada.Fo...
Could you check that your WLC's configuration matches the configuration from this guide:https://www.cisco.com/c/en/us/support/docs/wireless-mobility/wlan-security/217043-configure-dynamic-vlan-assignment-with-c.htmlThe guide uses Cisco ISE but if you...
You need to open a tac case and request them the files that are mentioned on the Cisco article, the author of that article seem to missed to attach the files.
