Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Rachel,with the current VCS software (X7) you have two options, FindMe Source Rewrite and CPL-based static source rewrite.FindMe Source rewrite is described in more detail in the VCS Administrator's guide.For CPL-based static source rewrite, pleas...
Javier,While waiting for X7.2.2 to be released, you could configure the VCS B2BUA and Lync to communicate over SIP TCP rather than TLS.On the VCS side, on the B2BUA configuration page, the only changes you have to make is to configure the 'OCS/Lync s...
Javier,I suspect that the VCS you are using is running non-encrypted VCS software, is this correct? To check this, go to Maintenance > Option keys and verify that 'Encryption' is not listed in the 'Active options' field under 'System information'.If ...
Javier,normally, in the case where the VCS initiates the TLS connection, VCS would send a Client Hello to the far end, where the far end should respond with a Server Hello. I still don't understand what you mean by "the FE answer with CA' and 'The VC...
Javier,where exactly in the TLS handshake in WIreshark are you seeing the VCS sending its own IP address instead of its FQDN? In the server certificate installed on the VCS, does the Subject Name and/or Subject Alternative Name contain the VCS FQDN?C...
