Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,if I attach the below acls I get slow throughput and high cpu on a sup2t with ios 15.2. If I copy a file with scp from 172.22.91.41 to 172.22.152.x with the acls attached I get 4.4MB/s and without the acls 111.7MB/s. What's wrong with the acls ...
Hello,I have this 3 interfaces on the ASA and want to config two vpns. Users should be possibleto connect from inside to mgadm and from outside to mgadm, but i can't get it work bothdirection at the same time. I need the NAT exemption for outside->mg...
Hello, we have a dot1q tunnel to our co-locationand can ping the servers in the co-locationover IPv4, but not over IPv6. The serversget an IPv6 address through the dot1q tunnelfrom the router interface per statelessaddress autoconfiguration, but I ca...
Hello,i have a Cisco router 2811 (IOS 12.4) with a etherswitch modul HWIC-4ESW and i want DHCPon the switch ports. Is this possible ?I get DHCP working on the router ports, butnot on the switch ports and i wonder if thatis possible at all.. i don't w...
Hi all,maybe not the right place to ask, but maybe anyoneknows it. Is it still possible to get a new motherboardfor the Cisco 3640 router from Cisco ? How much would it cost and what would be the part number ?Thanks !RegardsR.Weidemann
Yes, version is 15.2 and as soon I start the scp the load get highan IP input usage CPU..fb4_int2#sh versionCisco IOS Software, s2t54 Software (s2t54-ADVENTERPRISEK9-M), Version 15.2(1)SY5, RELEASE SOFTWARE (fc4)fb4_int2#sh processes cpu sortedCPU ut...
You mean I need two different vpns for inside and outside with two different ip pools, so i have no conflict by nat exemption ? Its also not possible to use one vpn config for two directions ?
