Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hey guys, So I setup a syslog server the other day in our office to monitor our 5512-x. I have noticed my outside interface denying a ton of telnet and ssh attempts to my firewall. I traced a few of the IP's and they came back from China and some fro...
Hello All,our vpn clients can no longer access internet while connected to vpn.I was hoping I could get an answer on here for an issue we are having. let me explain this with as little words as possible.here was old network layout:ASA192.168.1.1 --...
Hello all,I have setup a 4500 series core/router.. the customer decided to run dhcp off the router for whatever reason... I have 20 different scopes handing out to their vlans... Does each vlan interface need an helper address?vlan...
Hello all,I have a question about the 1262 when joined to a controller. Is there a way to increase the antenna gain on the raidios for increased distance? I have a 12dbi hooked up but i noticed in a show run that the output shows ...
Hello All,Need to re-design our network layout to accompany guest networks and some seperate vlans. Currently we are 1 vlan connected directly from a 2950 to a 5505 asa. I would like keep vlan 1 the same so I dont have to reconfigure all of our sta...
According to TAC, if you have call recording enabled, you will have a delay when answering.
Call recording behavior
Users see an icon on their Multiplatform phone (MPP) and the Webex App showing that a call is being recorded.
Users and workspaces ...
We have the same issue as well. We are a partner and have many WCX customers out there, but our own system has this delay and we have been unable to figure out why... CSAN, network, jitter, everything is fine.. Going to open a ticket and see what's g...
In the exact failure that you had your solution is very simple. for your default route ( for ex. 0.0.0.0/0 98.100.100.1 1) the last 1 being your AD for your static default route. so for your backup route you just can increase the metric or AD for ex...
Your best bet is creating the new AS in your core with the exact config as your other AS. from there hit each branch router and you should be able to rebuild it without issues. you didnt give any amount of downtime but you would be looking at branch ...
