Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello @ all, We currently operate a Wi-Fi network with 802.1x authentication based on a Freeradius distribution.Now we want to switch to the ISE 2.6. As far as everything works, however, a fact bothers me. In the "Policy Sets" we have created a new p...
Hi@all,
i have a problem.
I want to connect the Firepower Management with my smart-account.
The direct connection with Cisco works, all licenses are available.
For the security i installed a "Smart Software Manager satellite", this is connected wit...
Hi @All,
we have installed a new instance of a Prime 3.0 /3.0.2. We get the error below:
INIT: Id "S0" respwawning to fast: disabled for 5 minutes"
It seems an Linux error. Maybe somebody has a resolution?
Thanks :).
Hi@all, maybe i'm blind or something else. But there i could undeploy my templates from the controllers? Deploy isn`t the problem, this function i have found. Kind regards
Hi@all, at the moment we have deployed some 5760 and have a lot of problems. We have reognized that cisco has deployed the new 3.3.4SE ios for the controllers. In the Release Notes we could see that Prime 2.1.2 is compatible with this release. In the...
Hi,
so the image works well, but we have problems with the SMART-Accound. could it be, that a downgrade to the ASASFR image is impossible?
I get the whole time Bad Magic Block errors....
kind regrads
But, if i have for example an "WLAN-Template" (config for a SSID), in previous versions i had the possibility if i don't need the template at the controllers, to undeploy the template and keep the statistics in prime. Now, i have only the possibilit...
Thx for the feedback Rasika, Then i hope they deploy the release as soone as possible. Because the combination Prime and 5760 are at the moment not so funny... regards René
Thx for the help. But one last question:Scott Fella schrieb:There isn't a direct upgrade from WCS to PI 2.0. You will need to upgrade WCS to NCS 1.x and then to PI 2.0.After all of these informations, we have decided to install a complett new PI 2.0...
