Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear Team,I am using Avaya VPN client & when I am getting connected succesfully to IPSec VPN Server, it is showing in status that IP NAT-Transversal is active on port 10001. In this case my IP is behind the NAPT router. When I am checking the logs, i...
Hello friends,Happy New Year.Please help me to understand the below :•1. In my router I have two tunnels, Tunnel1 & Tunnel2. I have created a route-map named as “SMTP” to forward the traffic of port 25 (SMTP) through the Tunnel1 & if this is no...
Dear Team,I am using two ISPs on my Cisco 2901 Router. Gig0/0 is Primary ISP & Gig0/1 is Backup ISP. At any time, both the ISPs are up but being the Primary ISP (having primary default-route), Gig0/0 is forwarding my traffic. At any moment when I am ...
Hi,I want to send the traffic from specific source through specific interface & I configured the switch as below :config# Interface gig1/2config# description WAN_INTERFACEconfig# ip address 14.140.17.66 255.255.255.252config# Interface gig1/3config# ...
Hi,I am going to configure the storm control in the switches & I am using the below commands ://interface <interface-list>storm-control broadcast level 30.00storm-control multicast level pps 5 3//I am applying this for all the access ports of the swi...
Even if the backup link goes down logically (link is physically connected), I don't have any issue but if I am removing the physical link, then only I am having issues i.e. it is affecting primary link as well.
Hi The routes are correct. I have verified them. Please note, there is not any issue with the auto-failover when both the links are connected (interfaces are up). It is making the difference when the backup interface cable is plugged it from router.B...
Hi Alain,Thanks for the reply. Please tell me what can be the impact of Track 2 ?I faced one problem in which both the WAN 1 was down which made Track 1 down but when WAN 1 came up, the Track 1 in the router was not up. So, I had to add the another d...
