Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I hope you can help me. I am not sure what I'm missing in this configuration. I've 2 PC's in 100.0.0.0/24 Vlan 100 on a 3550 switch. I've created an SVI 10 connected to my sky router (192.168.0.0/24)Here is the info:Top#sh ip int bri | exc unaI...
Hello,I'm trying to test port-security in my c3550 but when I show port-security int f0/23 shows it only "Disabled" as below: sh runinterface FastEthernet0/23switchport access vlan 200switchport mode dynamic desirableswitchport port-se...
Hi,I hope you can help me since I'm having problems configuring my PIX 501. I have set e0 and e1 static ip addresses and they both comm. with their own segments. HOwever, I can't comm. from e1 through e0.I've set in both NAT (inside) 0 0 0 and outsid...
Hi,I'm trying to communicate 2VLAN's in a 2900XL to a 2600Router. My 2600 supports dot1q so I changed the encapsulation and set 2 sub-interfaces on Eth0/0. However, seems there no comm. between 2hosts on the diff. subnets (e/vlan)I've configured both...
sorry forgot to add sh vl briVLAN Name Status Ports---- -------------------------------- --------- -------------------------------1 default active Fa0/4, Fa0/5, Fa0/6, Fa0/7 ...
Jorge,Im a little confused on the NAT and PAT but this is what happens when I put the commnad.e0=2.2.2.2 =>outsidee1=1.1.1.1 =>insidepixfirewall(config)# global (e0) 1 1.1.1.1Global 1.1.1.1 will be Port Address Translatedpixfirewall(config)# 105: ICM...
Sure!Sorry, I didn't realize how bad it was. I'll put it here:PIX Version 6.3(5)interface ethernet0 autointerface ethernet1 100fullnameif ethernet0 e0 security10nameif ethernet1 e1 security99enable password 8Ry2YjIyt7RRXU24 encryptedpasswd CRA9.3/nTx...
