Hello All , I am really having a very strange case , XR2 is a vpnv4 route refelctor . In the same time it is having a vrf FOO with a loop back configured in it . XR2 is having a multihop ebgp session with R4 . Problem is XR2 is sending...
Hello All , I was having the below network ---((MPLS))----R2(PE)--(Area 0 )---R1----(Area120)----XR2---(Area 0)---------(PE)XR1-----------((MPLS)) , XR2 was having a loopback in Area 20 , and nor...
Hello All , I was trying to do this simple PBR on an ME3800 switch "15.2(2)S1" .===================================================================R2#sh route-map testroute-map test, permit, sequence 10 Match clauses: ip address (ac...
Hello Can any body advise how can I enable LDP on IOS XR interface BVI , when I type mpls ldp interface ?I can not see BVI in the list .I have even tried to use the autoconfig command under ospf but no joy , it does not show up when you type "Show...
Hello I am working on a project where I have encountered a catlayst switch with the vlans created only using "interface vlan" command interface Vlan163 no ip addressThere is no "vlan [vlan id] " comanad to creat the VLAN , can any body send me a ref...
Hello Rolf , Your are answer is focused on Intra area traffic , but my question is about Inter-area routes . Question is if you are part of the BB area , is it allowed to use LSA 3 from non-backbone areas Yes or NO...
unfortunately this is a customer`s that I do not admin , and getting this is not that easy but I am trying to do so . But for now can we really do so ? ( mean creat a vlan without a vlan command) ?
