Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,A question, is it possible to give 3 network pleased on the Outside of a PIX Firewall access to the Internet trough the PIX fireall and into the Internet connection pleased on the inside of the PIX?The problem is that if my 3 network needs to go a...
Hi,Got a customer who has the need of changing the bandwidth for some of the cable modems in his network - we can do that by saying this modem must have this policy. But there is 16 different IP subnets in the cable network. And management will be a ...
Is there any BGP session between the two IBRs? Also are you receiving full BGP table from both providers?
If so, you need to remember that if the primary BGP peer is lost, then between the routers a withdraw of all learned routes, this takes a bit of...
You’ll need to use the MLS flow commands, since it running with the SUP720, like “mls flow ipv6 inteface-full”, the configuration is quite similar to your IPv4 netflow configuration.mls flow ipv6 interface-fullmls nde senderip flow-export version 9ip...
You’ll have to use the documentation as a reference guide, your module might not be located in slot ine, but could be located in slot two instead.You can verify this with show diag and find the module location there.When you have located the slot, th...
Sure, there is no problem in using sub-interfaces on the ISR, it's the same as every other IOS router configuration:interface Gig0/0/0 no ip address no shutdown!interface Gig0/0/0.100 encapsulation dot1q 100 ip address A.B.C.D X.Y.Z.Q no shutdown/And...
Sure, there should be no problem in using a VSS node as a P or PE node, however you do need to be runinng Advanced IP Services software on it. For using VSS port-channels as label switching links, since they can run layer 3, there should be no issue ...
