Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
First let me say I'm not yet impressed with Prime 3.
I have at present 74 APs, mostly 3702E, installed and working. The problem is that three of them are showing in Prime as not registered/not associated, and one doesn't show up at all.
If I check t...
I've been doing video conferencing for years either over our network between sites or via ISDN to the world. We are now installing a system with a VCS Control, a VCS Expressway, a MCU 4501, and soon TMS to run the whole show.During the initial config...
Following the Release Notes for the 3520, I had the built-in IVR automatically register with the gatekeeper. This causes the following transactions on the 3520:"New message sent -> Gatekeeper Confirm to endpoint"followed immediately by:"terminal-type...
Thank you for the quick response. Am I correct then that this means that I can't register an endpoint with SIP or make SIP calls between two internal endpoints until I have a public IP registered with a name that I can then use for my SIP domain?Step...
I would love to open a case but even though our entire company runs on Cisco products, because I didn't know to order the support package for this I am told I have no support for this one device. I guess I am now the proud owner of a $8500 doorstop.
