Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have recently installed and initialized IPS module on ASA 5520 with help of cisco tec-support. But i dont see any traffic on IPS Dashboard. Our previous IPS 4240 shows alot of hits on its Dashboard. Why is this?
i need to design a site-to-site VPN and VPN for remote users. I have attach a drawing, need to know if this is good setup. Mostly my concern is security.Im using ASA5520 for edge firewall and Linux firewalls are for additional security.I have to crea...
Hi there,We are planning to setup QoS on our network.Its basicaly a windows network enviroment.We have 2 branch office connected to Data Center over 2MB private lease line. These lease lines are connected to a trunk port on cisco catalyst 4948 switch...
Hi there, Im trying to configure our cisco catalyst 4948 switch management port. I have gone through this document http://www.cisco.com/en/US/docs/switches/lan/catalyst4500/12.2/50sg/configuration/guide/sw_int.html#wp1138747 i have created ip vrf mgm...
Hi there,I have attach a diagram of dmz setup using a cisco soho router, cisco IPS, cisco asa. I want to know how i can stop an attacker. currently from IPS i can block a host. But even i block the host from IPS, i still get alerts from that attacker...
I have attached the file you requested.The IDM version is 7.1Cisco IPS Manager Express 7.2.3Here Below is how i have initalized IPS module and how i have send the traffic to IPS on ASA5520.access-list outside_ips extended permit ip any anyclass-map i...
In configuring VPN setup on ASA we have to define Encrypted IP address, like as belowaccess-list inside_nat0_outbound extended permit ip 172.16.9.0 255.255.255.248 192.168.1.0 255.255.255.0access-list outside_1_cryptomap extended permit ip 172.16.9.0...
Thanks everyone. It really help and now its working after i run thoses commands on both the ASA and PIX firewall.Now I want to run ACL on VPN tunnel. Suppose i want to create an ACL to allow only to port 80, says there is a webserver running on SITEA...
Still doesnt work. Below is the configuration of both ASA and PIX. Pls let me know what is wrong with this configuration.ASAinterface GigabitEthernet0/0 nameif outside security-level 0 ip address11.11.10.1 255.255.255.248 ! ...
