Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm just looking for information on the IOS zone based firewall in HA mode also running DMVPN and if its possible, supported and a good idea or not. I would prefer to use 2 HA break out firewalls for firewalling and DMVPN +internet on 2 ISRs dedicate...
I'm moving a customers ASA from client address pools to DHCP address assigment for VPN clients anyconnect and also IPsec client.When I make the change, the first client connects fine and receives an IP address OFFER from the DHCP server which is ACK'...
Hi,I'm trying to set PAT for an SMTP server which I'm told only can only run on the standard port 25 on the server, however as this is blocked by many ISPs, I've been asked to set up a translation on the firewall (PIX 525 running software v 8.04) for...
HiI'm trying to xmodem an image on to a recently purchased, secondhand 6509 sup2 MSFC2 which is completely offnet with no image on there at all.The problem is that whenever I try using xmodem to transfer the image over from my laptop it fails, for an...
Hi,A quick question about policing I'm trying to understand the parameters from my policy-map and wondered what the following meansclass 4mbps-at5-No1 police cir 4000000 pir 6000000 be 750000 conform-action transmit exceed-action transmit ...
Hi,
If I understand you would like the primary default route for R3 to be preferred over the leased line via R4 because you do not want to redistribute the external BGP routes into EIGRP. If so, in that case you are left with the default route, unl...
Then your switches and design should work. What is the remaining issue, that you need to have secure vlans?
If so you can create ACLs specifically for your needs applied to the SVI inbound
So if you know how to enable routing and default routin...
By best path to the cloud do you mean from R3 always use the path outbound from the same site using the other site only as backup?
If so then the eigrp metric of the default route will do that.
Eigrp metric to the default route from the ISP via R...
Hi there,
step by step configuration guide is a bit tricky but what you essentially want is NAT for the web and mail server so they can reach the internet.
NAT for the public facing.
90.x.x.1 > web server
90.x.x2 > mail server
external interface ...
Hi
If you would like to direct the inbound traffic to the server via a single primary path? it would come down to what the ISP will let you advertise to it in terms of subnets.. I did something like it before because the ISP allowed me to advertise...
