Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We recently began upgrading our High School network with Cisco 2960x switches. Immediately after the installation of the first switch in our MDF, our Bosch DVR camera systems started freezing in video playback. You can see the bandwidth reading of ap...
Today when I connected my serial cable to the serial port on the 2951, I noticed BGP session-5 messages scrolling even before I logged in. In fact it was disrupting username and password entry. How does on disable those messages from scrolling until ...
I am trying to create a very SIMPLE - initial config for my 2960x switches and after some initial settings I perform a show run and all looks OK. Then when I perform a write mem and log back in, I see a major change to the running config with numerou...
Trying to use the CNA to connect to my 3825 router, in preparation for 2960x switches we are going to purchase. I cannot connect using http - read/write. It seems as though the username and password fail. I can however, connect Read – only Level 1, a...
Why can't i connect with CNA to my 3825 router with network assistant using http - read/write. It seems as though my username and password fail. I CAN connect http - read only.
I think I found the answer to my own problem. It is the result of IP Device Tracking enabled causing the duplicate IP network error to the Bosch DVR systems. I am going to roll back my 2960x switches to 15.0 and run with the IP tracking disabled by d...
Thanks Sumi for the quick answer. I actually found the answer to my own question shortly after I posted, but I was in panic mode at the time of posting. Thanks again for your help. Pat
Glen, you were the correct answer. After extensive tests I found that if I turn off the default http secur-server, the pki hash does not appear on the show run config. Thanks also to Rolando for his help and concern. I guess my other Cisco components...
OK, Here is what I did. I only added a username and added an IP and mask to vlan 1. I then did a write mem and then a reload. After the restart the config came back with the crypto pki lines. The Ip http secure-server is on by default, so I will try ...
