Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I've seen this happen for years. Primarily with the C9300 platform, but I could have seen it on the 9200 and 9400 as well. But I know it definitely occurs on the 9300. And it isn't limited by IOS (IOS XE) versions because I've upgraded across many...
We are using ISE 2.1
I would like to create a new SSID called employee. When the employee authenticates, if we have identified that the device that the employee is using is owned by the company, we want to continue the authentication process and c...
Has anyone successfully connected a Polycom HDX8000 unit to CUCM 7.1? If so, do you have any configuration guides, howtos, etc.? I have something from Polycom that seems to leave out some steps as I think it was done for CM 5. The HDX8000 that I h...
Good Morning: I'm reading through this. I have a work around that does not involve adding dialing plans. I'm not sure how this will impact most of you. But in the directory synchronization program, you can set the IPPhone field to be the one that ...
Abdu,On one of my earlier posts, there is an attached document, the title starts with HDX. I used that as the instructions. I have to say I didn't completely understand it all, but I generally got the concept. I would say that even if you don't fo...
Polycom sells as a software enhancement to their codecs the ability to do multi-port conferencing - either video/video or audio/video. It essentially enables a multi-point bridge within the framework of their video systems. That way you can do I th...
I went back through the directions and tried a few other things, and the Polycom finally did register with CUCM. We have been able to place and recieve audio calls, and mix audio with video. I found out we did not purchase the multipoint option fro...
The Polycom is directly attached to the CUCM. There is no phone, no SCCP involved. Your last statement about connective via a SIP trunk and no MTP is exactly what I am after, and I have directions from Polycom to make this happen. Unfortunately th...
