Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi to all,
I read many guides and posts but it is still not clear.
I have a question regarding STP Type between a pair of Nexus and Access Switch.
1. Nexus peer-link Nexus
VPC
Catalyst Access Switch
Betw...
Hi to all,
I need the secondary POE OUT Port on the C9124 in vlan 99
RAP switch config > trunk with native vlan 201 , which is my mgmt for my access points
RAP config > see picture 1
MAP config > see picture 2
I can ping RAP and MAP.
VLAN Transparen...
Hi to all I just want to connect the AIR-AP1562I-E-K9 to my C9800 controller. The Access Point comes in bridge mode but I need the AP in local or flex connect modeI do not want to change the mode on the cli because I have many of those. All AP´s sho...
Hello to all, which Access Points are supported with the the embedded wireless controller.Which access points can i connect to the EWC. Thanks in advance Regards Alex
Hi to all, just a short question.Hi to all We have a wireless controller and want to reach airprint services in the wired lan via wireless clients. Do we need multicast routing in our LAN or just bonjour gateway mdns on the controller. Of course, it...
Hi,
that is exactly my question.
But you will never see a diagramm where the ports configured as network type, only normal.
And what about an ISSU update when all ports configured as normal.
BR
Alex
Hi,
thanks for the picture. It is from the design guide. But we have only VPC in this design.
What about a single attached access switch or a connected switch with two uplinks and
one link is blocking
BR
Alex
Hi to all are there any extra costs to install the EWC.Just need another software, right ? Without any additional costs C9100 EWC AP bundle image Thanks in advance Regards
