Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a pretty simple point-to-point bridge setup using Cisco 1300 series bridges running the latest IOS. Bridge at the main site is the root, remote site is non-root. The bridges link up and pass traffic just fine. Problem is, several times a da...
Just installed an 837 adsl router at a customer site. Previous they were using a cheapo dsl modem provided by the dsl provider, they were getting 1.5MB down and 512k up. After putting in the Cisco 837 I'm only getting 800k down and 128k upk, what a...
I'm using a global NAT pool that spans 5 Class C subnets and I am NAT'ing all internal hosts to that pool. Strange behavior is that I am running out of translations, it stops handing out translations when it reaches somewhere in the area of 650 tran...
I have a customer using a PIX515 with Websense for Internet filtering. They are firing up a remote location where we will be installing a PIX 501 to create a VPN tunnel between the two sites. A big requirement of this project is that all web traffi...
A "show interface" does not show the additional ports at all. Additionally, a "show diag" shows that there is a module installed but says that it is not supported.
I also have a 3640 with a an nm-16esw but I cannot get the router to recognize the network module at all. I have upgrade the IOS to 12.4 (IP Base) something but still no luck. What version of IOS are you running?Thanks for any help.
Thanks for the suggestion. Turns out that the telco had "adjusted" speeds for many of their customers while I was installing this router. Basically they screwed up and reduced the customer's speeds, nice timing, eh?
