Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All! have a challenge...Am working of MS UAG DirectAccess and we have 6 sites out there.The requirement was to also have manage-out functionality working.To get this done we have 1 global ISATAP cloud. In each Datacenter we have a Cisco 2800 runni...
Hi, I'm having trouble in Prime 1.3 seeing the wired clients and getting all the devices in the Device center in the managed state. Can you point to the information on how to fix this?
Hi, the virtual controllers needs firmware 7.3. This however is not supported on WCS. It only supports up till 7.2.230 if i am not mistaken. We had to upgrade to NCS/Prime 1.2.ArjanSent from Cisco Technical Support iPhone App
That will off course depend on the traffic from the gig ports. If you have 48 ports using 10% load, you'll need 4,8 gig uplinks, so 5 gig uplinks. I would advise to start of with your best estimate based on your user profiles. Then monitor the uplink...
Hi, yes thjnk this is it.. You'll need the free Cisco Network Assistant fir these more advanced config modifications..Sent from Cisco Technical Support iPhone App
I hear what you are saying but it should be possible to get these routes in just as a WIN2008 server running as ISATAP router does.Before running external ISATAP border routers the MS UAG server was acting as ISATAP router.The routing table looked li...
