Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Customer has 6 AP541N model units in Cluster Mode. They are experiencing instability issues that require the AP's often to be rebooted. Firmware 2.0.4 is loaded. Anybody fighting similar battles and/or have any suggestions/tweaks that worked for t...
Our customer has 2 of the Cisco SF300-24 port switches interconnected with fiber.They bought (2) of the MGBSX1 gbic modules - 1 for each switch. They crossed one side of the fiber and are using these modules but are getting no link light. Are these...
I recently installed (4) Cisco AP 1142 for a customer in a high rise commercial building - almost in like a downtown area where almost 30 other AP's are seen by my inSSIDer 3 software. I have the AP's running on channels 1,6 and 11. I have the 5ghz a...
I am going to build a RAID5 config in my Cisco/Linksys NSS6000. I am going to buy (4) Sata drives but wasn't sure if there is a limit to the size of drives that the NSS6000 can handle. I was thinking of getting (4) 500gb drives but am seeing 1.5...
I have a flat network and am trying to get Push to Talk working on 2 Polycom phones. Both phones are on the same vlan. How do I enable multicast on the 3548? I would think it would be enabled by default. 224.0.1.116 is the muticast address that t...
Thanks for the reply. I will have to do some more testing to qualify this. What is your opininion on the use of the command "ppp multilink fragment disable" on a Multilink interface? It seems that my research shows that is a good thing to have in ...
I have one router, 2 different ISP's. I am already using weight on the t3 interface for outgoing traffic.PRTG shows more incoming traffic to the t1 then the t3 and speedtests show t1 speeds unless I shut down the t1 serial interface and retest.When ...
I use PRTG and I still more traffic coming in via the t1 instead of the t3.when i use speakeasy.net/speedtest.html to test our speed, it shows t1 speed. when i shut down the serial interface for the t1 and test again, I get t3 speeds.I have one rout...
