Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all;I have a client with a UC540 where voice-mail functions have failed. The unit will not answer incoming calls although all parameters are configured and were working until this fault. CUE diagnostics run successful but you cannot access anythin...
Does anyone know how to restrict the UC500 from using specific outbound FXO ports? Presently they have 2 ports; 1 for fax services and the other for voice services. However the dial plan ignores the port status and will squentially access the ports t...
Has anyone had an issue creating a guest vlan to use the WIFI on an 891W router? The IOS is version 15.1. I have created discreet Vlan's and setup subinterfaces on both the WLAN_AP0 and GigaEthernet 0 interfaces with dot1q encapsulation. The client ...
I have a client with 2 vonage ATA (3 PSTN) lines. Each of the primary lines are registered to a different area code. The UC520 setup has one ata as a local for #1 area code (905) while the other is local for the second area code (705). A third line i...
Has anyone tested CCA with Windows 7 and if so were you successful? I have several clients looking to upgrade soon and would appreciate any & all feedback regarding challenges before running up against them in the field.
Hi James;thanks for your comments here. I agree I prefer to use the CLI also but had been warned not to circumvent the CCA as it can cause instabilities.I do know the UC is now EOL but just trying to keep my client operational until they decide to u...
Hi Dan;Thanks for the reply.I am using CCA and have setup the trunk ports in every possible way (sequential, least active, etc.) but I have been told the UC520 will ignore this and rotate through all the ports. This seems to be the case as I only hav...
Stephen;We applied the nat and acl as suggested but with no success. The client has also stated he cannot receive an IP from the pool. When creating the pool do you need to define for both 2.4 and 5 GHz radios?
Hi Stephen;Thanks for your reply.I will recheck the ip nat inside for this wlan interface today when onsite. I assume it will need to be applied to both 2.4 and 5 GHz radios as it is unknown what device the guests would attach?Since the corp users ne...
