Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a 5506-X to be used with a cellular modem attached to a 2nd interface for redundancy. The ASA is using IKEv1 for redundant tunnels as well. Through the VPN I can connect to the inside interface of the ASA as well as devices behind it.
What I...
I have a 891F router that was intended to connect via the SFP port to a IE3000-4TC. One pair of SFPs (GLC-FE-100LX) were purchased. Both appeared as compatible in the compatibility matrix.
However on the 891F I have speed 100 hard set, unable to c...
In PacketTracer 7.1. the WS-C3650-24PS is able to do 1:1 static NAT. Recently for a project we got in a WS-C3650-24TS, for which 1:1 NAT was not an option. I did a quick Google search and found most commented was that the L3 switches do not do this a...
I am trying find a solution to having snmp trap sent from the ASA, but delayed by 1-2 minutes after the event that triggered.
Background- The ASA is using SLA feature providing redundant backup on 2nd interface connecting to a cellular modem. The A...
I have 3 IR809 routers that will use directly connected ethernet radios with cellular interface as backup. R1 is the primary (CTU) with R2 & R3 each needing to independantly tunnel back to R1. I have tried ip sla, and while that in itself works, the ...
Thanks all for your help on this, it was a good lesson to learn. The role of the 2 VZW routers are for a VTI tunnel, and I was paying more attention to configuring that tunnel than anything else. Now this all makes perfect sense. Again, thanks all, t...
Yes, that was a typo I just corrected the text. And yes, they are on the same VLAN, but as I understood since the Edge routers were configured for 192.168.0.10 and the VZW were configured for 192.168.0.117, this would not conflict as the Edge routers...
Sorry I got confused. Here is the full existing config for the edge routers that I have no issues with;
R1 Edgeinterface GigabitEthernet0/0/1 ip address 192.168.0.1 255.255.255.0 no ip redirects no ip unreachables no ip proxy-arp ip nat inside ip nb...
The firewall's default gateway is 192.168.0.10 which is VRRP between the 2 edge routers, with R1 Edge as the primary. As for physical IP, I don't understand what you mean?
On ISP#1 I have 03.13.04.S and on ISP#2 I have 03.16.04b.S. When I do "ip nat service sip udp port 5060" it has no effect on either router, the command does not show up in the config. However on a 881 (v 15.2(4)M4) the command does show up in the con...
