Does the "service config" command work anymore on the cisco IR829GW. My scenario is that I am factory defaulting the router and trying to load a default config using tftp. I am seeing the usual output on bootup where it broadcasts to a tftp serve...
Hope you can help me out
I am trying to achieve the following scenario
These two parts are working
PPP user --> LNS Router -->Radius
Radius --> LNS Router
I am having trouble getting this part working
LNS Router --> DHCP Relay
I found a way to get this working.
When the interface sub commands wouldn't work, I turned to global commands instead.
What I did was create a global reference to a dhcp server using
ip dhcp-server 18.104.22.168
After this, the DHCP request was no long...
Thanks for the replay. I added that command but I am still seeing the same issue.
Virtual Access 1 is down but 2 is up
Virtual-Access2 is up, line protocol is up Hardware is Virtual Access interface MTU 1500 bytes, BW 100000 Kbit/sec, ...