Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am trying to decide which to deploy to a site that has a little over 100 users and they use a lot of features with their current phone system setup. For example, one setup is ring once to 'x' user and if they dont answer forward the call to 'y' gro...
I have been trying to setup WAN Optimization between two of my sites over a DMVPN Tunnel. I have a Cisco 2811 at one site and an ASR1001 at the other. The problem that i run into is that the host or hosts i specify in the ACL (to participate in the W...
I currently have the Mobility feature configured so that my Mobile Phone rings at the same time as my Cisco IP Phone. Problem is that my mobile phone does not start ringing until the second ring of the IP Phone. There are a total of 3 1/2 - 4 rings (...
I am trying to configure WCCP on my Routers in a DMVPN environment, in order to setup WAN Optimization. The issue is as soon as i activate the WCCP service on my ASR or any router at my remote sites with either 'ip wccp 98 group-list ACL' or 'ip wcc...
Gotcha. How about Attendant Console or something like it? is there a solution best fit for a receptionist using the CME? maybe just a sidecar or something?
Beau - thanks, i'll give that a shot too and let you know.Ahsan - 1. Its a VM based WAN Optimization Client called Certeon. 2. Yes. This happens as soon as WCCP is enabled globally before i even apply it to an interface3. No specific services are bei...
