Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I have a PIX 535 firewall which has GBIC module and I need to connect to a Switch 2360 / 2960 which has 10 Gig SFP.Can I connect using multimode fiber. Will it work?Or is there any Speed configuration we can do to reduce 10 Gig to 1 Gig in the ...
I have ACS 1131 with 5.2 version software.Can this be configured as a VLAN Membership Policy Server for dynamic vlan assignment in the switches.If possible, Can anybody provide me the configuration steps or ideas.Thanks & Regards,Lenin S9620745656
HI ,I have a PIX 535 connected through OFC to Cisco 2960 Switch.PIX end - G0 (SC type Connector) - Switch End - Gi1/0/28 (LC type connector) When I am pinging from either side, I am getting packet drops. CRC error is increasing at PIX interface.Spee...
HI ,I have a PIX 535 connected through OFC to Cisco 2960 Switch.PIX end - G0 (SC type Connector) - Switch End - Gi1/0/28 (LC type connector) When I am pinging from either side, I am getting packet drops. CRC error is increasing at PIX interface.Spee...
I have a Cisco Aironet 1200 Series Access Point. It takes long time to boot up.After showing the warning banner message it takes long time before asking for username. Please suggest.The sh version is given below.Cisco IOS Software, C1200 Software (C1...
Hi, Thanks a lot for the reply. I still didn't check this. I will update it soon.Also I require another information. I want to authorize show config command for level 4 user. Can this be done ing ACS 5.2 or we need to authorize on all the devices onl...
Thanks a lot. Jorge. I worked out for me your idea. I would like to know one more thing.Only denied logs are getting logged in my syslog server now. I would like to save the allowed logs also, for the forensics later. How should I enable that.Is ena...
