I have a Cisco 2600 router. I have it plugged intoa catalyst switch where my pcs on the same vlan access it. The other interface is public and plugs into a shared switch which then connects into another router from our ISP out to the Internet. Fro...

I have a Catalyst 4000 switch. I have 2 ports particular set to 100 and Full Duplex (not autonegotiate). The two devices one these ports are Windows 2000 servers.When I do show port I notice there are FCS-ERR, XMIT-ERR and RCV- ERR errors. I also ...

I have changed the IP on my switch and it is reflecting properly in the startup file. It is a 3548 catalyst switch. For some reason I cannot Ping or Telnet.The default gateway and subnet is correct as well as the vlan #. The settings for telnet ar...

Below is a quick screenshot of a port on my Cisco Catalyst 3548 switch.I am interested in the Input Errors and what this typically indicates????What do the collsions indicate???? What does deferred mean???Also what is the likely effect on anything th...

I am using the Cisco TFTP software. I was able to make a copy of my config in the following manner:Copy Startup-config tftpI follow the prompt and it works. When I try to copy from the TFTP client with the following command: copy tftp startup-co...