Change IP on switch

adagost · ‎01-31-2003

I have changed the IP on my switch and it is reflecting properly in the startup file. It is a 3548 catalyst switch. For some reason I cannot Ping or Telnet.

The default gateway and subnet is correct as well as the vlan #. The settings for telnet are correct. Ip was able to Telnet before I changed it to the new IP address. The switch is functioning properly with the workstations connected.

Thank you

lgijssel · ‎01-31-2003

Please check the status of your interface vlan1, or what you are using. These interfaces are administratively down by default.

conf t

int vlan 1

no shut

end

wr

and you're back in business.

adagost · ‎02-03-2003

Thank you for your reply. This was not the situation. It is very strange that I can not get this to work.

7rbowenii · ‎02-03-2003

How did you change the address? Just the host ip or did you change the subnet/mask also? Did you change the VLAN for management?

-Bo

adagost · ‎02-10-2003

Even though I had my Vlan1 management shutdown I still had to do the no shut on Vlan 3. It worked. Thank you very much for your help.