Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have QM server and all its configuration is ok. The server was recording before but for an unknown reason it is not now.
I am not an expert in QM so I don't know from where to start the troubleshooting, would you please help.
The version is 9.2.
...
Hi All, does anyone has a document that shows the steps of adding a subscriber to an existing CUCM, the existing one has already a publisher and a subscriber.CUCM version is 7.x.Many thanks in advance.
Hi, i am facing a problem and i am looking experts advice.i have a 4510 switch. the switch restarted. and it stucks in the rommon mode. it keeps showing the config-register 0x0102 and i am not able to change it.in the rommon mode, i run the command d...
Hi,i have a 4500 switch which was used before to be a layer 2 switch connected to the core using trunk.i removed this switch from the network and put it in a separated network. i am trying to change it to layer 3 switch but the problem it is not conv...
i will try these commands as soon as i can.i have another question:i have 3 sites connected to each other using MPLS which uses bgp protocol. lets say i have site A , B and C. each site has core switch and access switches.site A:vlan 10 : 172.29.10.0...
the scenario here is that i created some vlans ...but i am not sure whether the vlans i created were existing before. and then i wrote ip routing and they are working fine. i am trying to add new vlans and it is adding the vlans but no routing betwee...
