About raymond.chuang

raymond.chuang · 02-19-2008

Has anyone tell what is "candidate default"? By the way, we often see one route path has been marked "*" on its prefix when multiple equal cost route paths presenting at "show ip route x.x.x.x". What does it mean?

raymond.chuang · 01-19-2007

We have used Cisco ASA to protect Cisco Call Manager. Could Cisco ASA filter IP Phone users to login Call Manager's admin page such as URI filtering?Thanks,Raymond Chuang

raymond.chuang · 02-23-2006

We have setup two set of bridge to interconnect our network for resilience design. Two pairs of 1400 bridges were connected to our switch, we found problem on the failover that the Ethernet connection to bridge is always up(active) even the pair of b...

raymond.chuang · 10-05-2005

We had a Aironet which needs to installed on dark room but its status LED always blink. Could we turn off the LED by configure? As I knew this AP can be configured continuously blinking the status LED.

raymond.chuang · 10-29-2003

The NetScreen was act as a VPN server, we need to make a LAN-to-LAN VPN from Cisco router or PIX to NetScreen. However, our Cisco router or PIX cannot get the fixed ture IP address from provider. NetScreen firewall was support the dynamic VPN LAN-to-...

raymond.chuang · 02-19-2008

I am not looking for the default route & default-network different. Has anyone know the meaning on the "*" of equal-cost route presenting at "show ip route x.x.x.x"? From the attached example file, it can see a "*" on prefix of route path 20.20.20.1....

raymond.chuang · 01-20-2007

Hi Raj,Right! CM is in inside, IP Phones and clients are at outside. We can't to filter https(443) as both phone user and CM admin need to use https to access CM's /ccmadmin or ccmuser folders. I found the URL filter need to bind with HTTP inspection...

raymond.chuang · 10-12-2005

Thank, that is for LED blink.But, we need to turn off the "Status LED".

raymond.chuang · 10-02-2002

Is it PPP Multilink (MPL) interleave?

raymond.chuang · 10-02-2002

It is not end-to-end Fragmentation. We use FR/ATM service interworking. One router encapsulate FR and ATM at anther router, i.e FR router (CE)<--> ATM router (PE),--> MPLS <--> ATM router (PE)<--> FR router (CE). Can FRF.12 work in this situation?

Member Since	‎08-16-2002 10:05 PM
Date Last Visited	‎08-18-2017 03:56 AM
Posts	13

User Statistics

User Activity

what is routing code "candidate default"(mark "*")?

how control access CM's "ccmadmin" page through ASA

Could auto bring Ethernet down when radio interface down on Aironet 1400?

Could power off the Aironet 1130 status LED?

Does Cisco product support with NetScreen Aggressive mode?

Re: what is routing code "candidate default"(mark "*")?

Re: how control access CM's "ccmadmin" page through ASA

Re: Could power off the Aironet 1130 status LED?

Re: Can FRF.12 work with FR-ATM interworking?

Re: Can FRF.12 work with FR-ATM interworking?