Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Currently working on a flexconnect deploment with serveral vWLC v8.2 and ISE 2.1 nodes.
We are having an issue with the HTTP redirect of the guestportal for the guest portal SSID.
We have 1 SSID with EAP/TLS working OK with the ISE.
The other SSID sh...
So im running a virtual WLC with v8.2.121.0 and am currently testing if AP's can join.
Since:
http://www.cisco.com/c/en/us/support/docs/wireless/virtual-wireless-controller/113677-virtual-wlan-dg-00.html
i upgraded the AP to c1140-k9w8-tar.153-3.JD...
Ok so i installed a few virtual WLC's with the following image "Cisco_AIR_CTVM_LARGE-K9_8_2_110_0".
I can see this image is also running in the VM/cloud environment.
But when i logon to the WLC's it says vWLC config: Small and only 200 AP's are suppo...
Ok so i have this setup of a WLC 5760 with about 400 AP's.
The edge of the environment is non Cisco so the AP's are currently connected to non Cisco switches.
For a proof of concept we implemented Cisco 3850's in 1 building.
At first i had the 3850 a...
So i had to upgrade a Cisco WLC 4402 which is located in Sweden and has H-REAP AP's connected to it which are located in Norway.
Since i have done these kind of upgrade's a few times onsite and it went flawless i thought what would be the problem doi...
We are currently also having the same issue's as you are describing and we are also thinking about creating a TAC case we are running ISE 2.0.1.130-Patch1 & 2
Did you ever solve this issue ?
Well for me the problem was i did not create the flex-acl globally only under flexconnect. Step 7 of --> http://www.cisco.com/c/en/us/support/docs/security/identity-services-engine/116087-configure-cwa-wlc-ise-00.html
So you need to create the ident...
mustehsan thank you for youre commitment.
I filtered the customer IP space appearantly i didnt use the same values my apoligizes.
I just solved the issue appearantly you need to activiate the license on the vWLC although it says it supports 200/300...
