Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All, I am looking for a redistribution wizard out there! I am currently studying my CCNP and have built a two-way redistribution topology with dual transit/redistribution routers. I have successfully redistributed routes from OSPF into EIGRP and...
Hi All, Wondering if an Security/SP expert could help me on the following... My end user has the following topology:- (Note for simplisity I have show a single FW, it is actually a pair in A/S.)Scienario:- There are 2 ISP lines on two separate interf...
Hi gnijs,
Option 1 is not very scalable.
With regards to option 2, SDA has three roles(well four if you include the control plane). Edge Node, Intermediate Node and Border/Default Border Node.
As you are aware, Intermediate nodes are just ro...
Hi KOE SIZE JIE, In regards to Q1 The 16 port switch module you have configured inside your router is a layer 2 device. This means all 16 ports are switch ports. You cannot issue a "no switchport" on these to get routed ports. In Regards to Q2 As p...
