Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
Upgraded ASA from 9.14(2) to 9.18(3). After upgrade Anyconnect can't connect. "Wasn't able to establish connection with specified secure gw. Try again"From ASA log.Authentication radius - passedAuthorisation ldap failed.In logs i see, that certif...
Hi,
I have a problem with dmvpn, when some spokes are coming from one nat pool. There is a network, that is protected with one firewall, that isn't under our management. As a result, all spokes use the same outgoing ip. With first conection all is o...
Hi,Our client have SCE 8000 and about 20 static subscribers. Each of them have about one or two IP prefixes. Changes in these prefixes are made once per two or three months.Primary target is to shape each of them with his per subscriber limit. Secon...
Hi,Client replaced a switch from 3750 to 35850 and got problems with port-security. %PORT_SECURITY-2-PSECURE_VIOLATIONThat is more interesting: Security Violation Count : 0It's not increased.WS-C3850-48T 03.03.01SEport config on old 3750:inte...
Hi,
First spoke establishing connection without problems. It means that configuration is ok for it. Problem starts with next one with identical configuration. I tried with and without ipsec.
Ugis
May explanation of problem wasn't quit clear. Problem is why router accepts packets from switchcard, that is addressed to other MAC address, and pass them to L3 routing process.
Here is log from client:Cisco Systems VPN Client Version 5.0.07.0410Copyright (C) 1998-2010 Cisco Systems, Inc. All Rights Reserved.Client Type(s): Windows, WinNTRunning on: 6.1.7601 Service Pack 1506 21:50:03.799 12/29/12 Sev=Info/4 CM/0x63...
