Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Expert,Any idea of where to find the config example/pinout for the VIC3-2E/M. what I have a new project where C2901 will connect to a radio system (Jotron TR-7750). this Radio will bring the anolog signal and the card VIC3-2E/M will be supporting ...
Hi Expert,I've a requirement to implement NAT-PT for 3 IPv6 customer they will be connecting to our one server IP within IPv4 network. I have no chose to chooseNAT64 instead of NAT-PT as we know NAT-PT is historic per RFC4966. So. I checked the link ...
Hello Edson,Thanks for the information. But that is not so clear as we think.What I found is in the 4900 configuration guide for QoS. A note on QoS trust boundaries.Cisco built the IOS for this switch considering that Cisco IP phone will wil be conn...
Hi All,Now I got it to work both way, PAT (port Address Translation) is many to one mapping, that is way I can ping from IPv6network to only one IPv4 address and I can see the ports # assigned by the NAT-PT router. Now As I said I had issues with out...
Weak up guys, no replies yet. Anyhow I got it to work with NAT-PT using PAT. I assigned multiple 2001 & 2003 v6 addresses in 2 diffrent routers ( 2001:A:B:F::1 & 2003:DB8:BBBB:1::9) accordingly and on the NAT-PT router configured the following:router...
Thanks Laurent,15.1(4)M1 with adventerprisek9- feture set supported IPv6 IP SLA. Need of course to enable IPv6 and assign IPv6 address on the interface to see the R1(config-ip-sla)#icmp-echo ? Hostname or X:X:X:X::XThanks again,Maz
Thank Laurent, do you know which code/feature set to use with c3800?as I tried 3 codes and when i enable IP SLA see below I did not see v6 choice, I'm looking for a code that will show up IPv6 address like v4 address below:AN1212#conf tEnter configu...
