Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,
I have a few stacks of 2960s operating normally but I see the following sporadic STP messages on some of them:
Root Changed for vlan XXX: New Root Port is StackPort4. New Root Mac Address is aaaa.bbbb.cccc (Stack-Hostname-4)Root Changed for vl...
Hi all,Can anyone tell me why ASA is unable to change its SSH service port and besides that it is telling its OS on simple telnet to port 22?I think this is very frustrating and I was hoping that Cisco will change this behaviour on the 8.4 version of...
Hello,Recently my company has purchased a wildcard certificate from GeoTrust and we have managed to install this certificate to some of our infrastructure servers. Unfortunately I am unable to install the same certificate to ASA for use in AnyConn...
Hi,I am using VSS configuration on a pair of 6509s with IOS 12.2(33)SXI3. After VSL link goes down the standby chassis sucessfully detects the complete VSL failure and initiates SSO correctly. This causes a dual-active scenario and the former active ...
Hello,I have the following problem: I am using a management-only interface on ASA 5520 with v8.0.4 software. This management interface is directly connected to a management inside network. The ASA is successfully managed through that interface, but t...
Hello,
I do not know if this thread is still active, but this command gives me very useful statistics about current interface bandwidth on ASA:
show traffic
HTH!
Regards, Kliment
Hello rrsstefano,
Seems like we have the same error.
The PC behind the IP phone is incorrectly assigned to the voice VLAN.
Did you manage to fix this?
I am about to open a TAC case for this.
Thank you!
Regards, Kliment
I cannot believe there is anyone that has observed the same behavior or has something to say about this?
What is your opinion on this behavior? Is it normal?
Hello,Does anyone have any idea? I am about to open a service request about this problem, but I was wondering that many of you must have done this before, as I suppose this is a usual procedure. Am I wrong?Thank you for the time spent Kliment
Hi all,This design problem is solved in N7K by placing the management port in VRF. Since the ASA does not support VRF (as far as I know) this is currently not possible. Hope this will be developed in future releases as well as some other very useful ...
