Hi, I just discovered this program and decided to try it out. I installed the 64-bit windows version. Here are my obervations I did not manage to get to work. Hopefully it is just a layer 8 problem. Jump host not working When I try to connect to a device the jump host does not build up a connection. Are there any settings on the jump host, that must be set before it is working? These are the commands, which are defined per default in the jump host configuration expect "jumpserver #" send "ssh $username@$hostname -p $port\r" expect "Password:" send "$password\r" Console Selection Behaviour is not working I tried double-clicking in the console but nothing happens. According to the feature guide the expected action should be to open it in the specified application. This is my understanding Refresh Device information For the device connection I manually use a jump host and then connect to the device. The CLI Analyzer then identifies the device correctly and adds a device entry with the jump host's IP address and the device's details like model, version and serial number. When I reconnect to a different device hit the Refresh Device Information button it checks the device, but the information is not reflected in the devices tap. It only does when I completely close the session and reconnect again. Mind you that I use a jump host to connect here, so that might have to do with it. Also when the program has identified the session as IOS and I try to connect to an AireOS WLAN controller I am unable to hit the refresh button. However starting the session with a WLC device I can connect to an IOS device and refresh the information without a problem. Any help on this would be appreciated Regards, Patrick ... View more

Hi all, I wanted to ask if someone here might have a newer version of the Zap performance tool, which includes support for TCP connections? The version available on the net (1.83) is a bit dated and does not have it. Regards Patrick ... View more

Hi all, I just read a white paper on 802.11u and there was a specific point on the advertisement of emergency services. This got me thinking. Are there currently any countries that have regulations with regards to VoWiFi, where emergency calls must be available at all times, in order to avoid situations where someone's life is at stake? I am curious, because if you are in such a situation, could you be held liable, if a call didn't get through due to bad Wifi design? Regards, Patrick ... View more

Hi all, I am currently checking out the new main dashboard in WLC code 8.2. I took one AP, which shows a very high interference percentage (>70%). I compared it to the values of the values in the traditional view (Advanced -> Monitor -> 802.11b/g/n -> AP name -> Detail). When checking the interference Profile values of the 2.4GHz radio they don't add up (didn't check 5GHz). The channel is clean according to the traditional view - Interference Profile states Passed - and 73% in the main dashboard. Here are the respective screenshots. Traditional view New view Does anybody know, if I might be missing something. Is there is something else added to to this parameter in the new dashboard, which is not accounted for in the traditional view? Best Regards, Patrick ... View more